P2401 severity depends on the specific fault. While some causes are minor (e.g., sensor failure), others can affect performance or emissions. Diagnosis is recommended.

Can I drive with P2401?

Short trips may be possible, but prolonged driving with P2401 active is not advised until the root cause is identified and repaired.

Will P2401 clear itself?

P2401 may clear if the fault is intermittent, but it will likely return if the underlying issue is not resolved. Use a scanner to monitor pending and confirmed codes.

P2401 - EVAP Leak Detection Pump Control Circuit Low

P2401 is a Diagnostic Trouble Code (DTC) indicating a fault related to EVAP Leak Detection Pump Control. This code falls within the Powertrain (P) category and is standardized across OBD2-equipped vehicles. When P2401 is stored in the engine control module (ECM), it means the onboard diagnostics have detected a malfunction or out-of-range condition in the EVAP Leak Detection Pump Control circuit or system.

P2401 - EVAP Leak Detection Pump Control Circuit Low

What is P2401?

P2401 is a Diagnostic Trouble Code (DTC) indicating a fault related to EVAP Leak Detection Pump Control. This code falls within the Powertrain (P) category and is standardized across OBD2-equipped vehicles.

When P2401 is stored in the engine control module (ECM), it means the onboard diagnostics have detected a malfunction or out-of-range condition in the EVAP Leak Detection Pump Control circuit or system.

Common Symptoms

Fuel odor near vehicle
Check Engine Light on
Hard starting after refueling
Failed emissions test

Possible Causes

Loose or missing gas cap
Cracked or disconnected EVAP hose
Faulty purge valve
Leaking charcoal canister

Step-by-Step Diagnosis

Connect an OBD2 scanner and confirm the code is present. Note any additional codes.
Review freeze frame data to understand engine conditions when the code was set.
Visually inspect the EVAP Leak Detection Pump Control and related wiring harness for damage, corrosion, or loose connections.
Perform a wiggle test on wiring while monitoring live data (if applicable).
Use a multimeter to check sensor/actuator resistance, voltage, and ground integrity.
Compare live data readings to factory specifications.
If circuit-related, trace the wiring diagram and test for opens, shorts, or high resistance.
Clear the code and perform a road test to verify repair.

Recommended Repairs

Replace or repair the faulty EVAP Leak Detection Pump Control if testing confirms failure.
Repair any damaged wiring, connectors, or terminals. Ensure proper routing and secure mounting.
Clean components (throttle body, MAF sensor, EGR valve) if contamination is present.
Update ECM/TCM software if a technical service bulletin (TSB) applies.
Replace related fluids (transmission fluid, coolant) if degraded or incorrect.
Verify repair by clearing codes and completing an extended road test under various conditions.

Related Diagnostic Trouble Codes

External References and Forum Discussions

Disclaimer

The information provided is for educational purposes only. Always consult a qualified mechanic for accurate diagnosis and repair. Diagnostic Trouble Codes can have multiple causes, and proper testing is essential before replacing parts.

Article generated for aiscanauto.com - AI-powered OBD2 diagnostics

P2401 - EVAP Leak Detection Pump Control Circuit Low

P2401 Diagnostic Trouble Code