P2716 — Pressure Control Solenoid "D" Electrical

OBD2 code P2716 flags a problem with the automatic transmission control (pressure control solenoid "D" electrical). Short, gentle driving to a shop is usually possible. Common culprits: faulty transmission speed sensor, low or degraded transmission fluid, failed shift or pressure control solenoid.

powertrain (engine/transmission)

Is it safe to drive?

Drive with caution Drive only if the transmission still shifts predictably, and avoid highway speeds. Driving with slipping or limp mode accelerates internal wear — every kilometre can add to the final repair bill.

How to diagnose with an OBD scanner

  1. Read the code and freeze frame Connect an OBD2 scanner, confirm P2716 is stored, and save the freeze frame data — it shows engine conditions when the fault was detected.
  2. Check for companion codes and TSBs Related codes often reveal the real root cause. Also check manufacturer technical service bulletins (TSB) for your make and model — many P0xxx issues have factory fixes or software updates. Search by VIN on the manufacturer site or nhtsa.gov.
  3. Inspect wiring and connectors Visually inspect the wiring harness and connectors related to the automatic transmission control for damage, corrosion, chafing or poor contact.
  4. Subsystem check Check transmission fluid level and condition — dark, burnt fluid points to internal wear.
  5. Subsystem check Read transmission-specific codes and live data (solenoid states, input/output speed) with a capable scanner.
  6. Verify the repair Clear the code, complete a full drive cycle including the conditions from the freeze frame, and confirm P2716 does not return.

Approximate repair cost

Repair cost depends on which component actually failed. Typical scenarios for P2716 (parts and labor, USD, independent shop rates): Transmission rebuild or replacement: $2,500–$5,500; Replace a shift solenoid: $300–$800; Transmission fluid service: $150–$350; Valve body repair or replacement: $700–$1,500. Overall, fixing P2716 usually costs between $150 and $5,500. An accurate diagnosis before buying parts saves money — the most expensive scenario is rarely the first one to check.

Common questions

What is the most common cause of P2716?

The most common causes are: faulty transmission speed sensor, low or degraded transmission fluid, failed shift or pressure control solenoid.

Will P2716 clear itself?

Sometimes P2716 clears after a few drive cycles if the fault was intermittent — for example a loose connector or a tank of bad fuel. The underlying cause usually remains, so the code tends to return. Clear it once; if it comes back, diagnose rather than erase it repeatedly.

How much does it cost to fix P2716?

Transmission rebuild or replacement — $2,500–$5,500; Replace a shift solenoid — $300–$800; Transmission fluid service — $150–$350; Valve body repair or replacement — $700–$1,500. Exact cost depends on the root cause, your vehicle and local labor rates — a proper diagnosis is the cheapest first step.

What does OBD2 code P2716 mean?

OBD2 code P2716 flags a problem with the automatic transmission control (pressure control solenoid "D" electrical). Short, gentle driving to a shop is usually possible. Common culprits: faulty transmission speed sensor, low or degraded transmission fluid, failed shift or pressure control solenoid.

How do I diagnose P2716 myself?

Start with a scan: confirm P2716, save the freeze frame and note any companion codes. Then inspect the wiring and connectors related to the automatic transmission control, and verify the suspect component against live data before buying parts.

What does P2716 mean?

Behind P2716 is a specific failure in the automatic transmission control: pressure control solenoid "D" electrical. The onboard computer stores it in the powertrain (engine/transmission) group after verifying the fault over repeated checks.

This code does not appear from a single bad reading: the module must see the fault condition repeat under defined operating conditions before it turns on the warning light. The freeze frame captured with P2716 — engine load, rpm, temperature, speed — tells you exactly when the problem occurs, so reproduce those conditions when testing.

What causes P2716?

  • valve body wear
  • failed shift or pressure control solenoid
  • low or degraded transmission fluid
  • wiring or connector faults in the valve body harness

Common symptoms of P2716

  • no movement in severe cases
  • shuddering at highway speed
  • transmission stuck in one gear (limp mode)
  • slipping between gears
  • harsh or delayed shifting
  • Check Engine or transmission warning light on

How to diagnose P2716

  1. Connect an OBD2 scanner, confirm P2716 is stored, and save the freeze frame data — it shows engine conditions when the fault was detected.
  2. Related codes often reveal the real root cause. Also check manufacturer technical service bulletins (TSB) for your make and model — many P0xxx issues have factory fixes or software updates. Search by VIN on the manufacturer site or nhtsa.gov.
  3. Visually inspect the wiring harness and connectors related to the automatic transmission control for damage, corrosion, chafing or poor contact.
  4. Check transmission fluid level and condition — dark, burnt fluid points to internal wear.
  5. Read transmission-specific codes and live data (solenoid states, input/output speed) with a capable scanner.
  6. Clear the code, complete a full drive cycle including the conditions from the freeze frame, and confirm P2716 does not return.

How to fix P2716

Start with the cheapest and most common causes before replacing expensive parts:

  • Transmission rebuild or replacement — $2,500–$5,500
  • Replace a shift solenoid — $300–$800
  • Transmission fluid service — $150–$350
  • Valve body repair or replacement — $700–$1,500

How much does it cost to fix P2716?

Repair cost depends on which component actually failed. Typical scenarios for P2716 (parts and labor, USD, independent shop rates):

  • Transmission rebuild or replacement: $2,500–$5,500
  • Replace a shift solenoid: $300–$800
  • Transmission fluid service: $150–$350
  • Valve body repair or replacement: $700–$1,500

Overall, fixing P2716 usually costs between $150 and $5,500. An accurate diagnosis before buying parts saves money — the most expensive scenario is rarely the first one to check.

Can you drive with P2716?

Drive only if the transmission still shifts predictably, and avoid highway speeds. Driving with slipping or limp mode accelerates internal wear — every kilometre can add to the final repair bill.

Related OBD2 codes