P1621 severity depends on the specific fault. While some causes are minor (e.g., sensor failure), others can affect performance or emissions. Diagnosis is recommended.

Can I drive with P1621?

Short trips may be possible, but prolonged driving with P1621 active is not advised until the root cause is identified and repaired.

Will P1621 clear itself?

P1621 may clear if the fault is intermittent, but it will likely return if the underlying issue is not resolved. Use a scanner to monitor pending and confirmed codes.

P1621 - Engine Torque Monitoring

P1621 is a Diagnostic Trouble Code (DTC) indicating a fault related to Engine Torque Monitoring. This code falls within the Powertrain (P) category and is standardized across OBD2-equipped vehicles. When P1621 is stored in the engine control module (ECM), it means the onboard diagnostics have detected a malfunction or out-of-range condition in the Engine Torque Monitoring circuit or system.

P1621 - Engine Torque Monitoring

What is P1621?

P1621 is a Diagnostic Trouble Code (DTC) indicating a fault related to Engine Torque Monitoring. This code falls within the Powertrain (P) category and is standardized across OBD2-equipped vehicles.

When P1621 is stored in the engine control module (ECM), it means the onboard diagnostics have detected a malfunction or out-of-range condition in the Engine Torque Monitoring circuit or system.

Common Symptoms

Transmission shudder at lock-up
Poor fuel economy
Engine RPM fluctuation at highway speed
Overheating transmission

Possible Causes

Failed torque converter clutch solenoid
Worn torque converter
Degraded transmission fluid
Valve body malfunction

Step-by-Step Diagnosis

Connect an OBD2 scanner and confirm the code is present. Note any additional codes.
Review freeze frame data to understand engine conditions when the code was set.
Visually inspect the Engine Torque Monitoring and related wiring harness for damage, corrosion, or loose connections.
Perform a wiggle test on wiring while monitoring live data (if applicable).
Use a multimeter to check sensor/actuator resistance, voltage, and ground integrity.
Compare live data readings to factory specifications.
If circuit-related, trace the wiring diagram and test for opens, shorts, or high resistance.
Clear the code and perform a road test to verify repair.

Recommended Repairs

Replace or repair the faulty Engine Torque Monitoring if testing confirms failure.
Repair any damaged wiring, connectors, or terminals. Ensure proper routing and secure mounting.
Clean components (throttle body, MAF sensor, EGR valve) if contamination is present.
Update ECM/TCM software if a technical service bulletin (TSB) applies.
Replace related fluids (transmission fluid, coolant) if degraded or incorrect.
Verify repair by clearing codes and completing an extended road test under various conditions.

Related Diagnostic Trouble Codes

External References and Forum Discussions

Disclaimer

The information provided is for educational purposes only. Always consult a qualified mechanic for accurate diagnosis and repair. Diagnostic Trouble Codes can have multiple causes, and proper testing is essential before replacing parts.

Article generated for aiscanauto.com - AI-powered OBD2 diagnostics

P1621 - Engine Torque Monitoring

P1621 — Codice di guasto