U0417 — Invalid Data Received From Park Brake Control Module

vehicle network

Is it safe to drive?

Drive with caution The base brakes usually still work, so careful driving is possible — but ABS and stability control are disabled, which lengthens stopping distances on slippery roads. Fix promptly and avoid harsh driving.

How to diagnose with an OBD scanner

  1. Read the code and freeze frame Connect an OBD2 scanner, confirm U0417 is stored, and save the freeze frame data — it shows engine conditions when the fault was detected.
  2. Check for companion codes and TSBs Related codes often reveal the real root cause. Also check manufacturer technical service bulletins (TSB) for your make and model — many U0xxx issues have factory fixes or software updates. Search by VIN on the manufacturer site or nhtsa.gov.
  3. Inspect wiring and connectors Visually inspect the wiring harness and connectors related to the ABS / stability control for damage, corrosion, chafing or poor contact.
  4. Subsystem check Read all four wheel speed PIDs while driving slowly — the faulty sensor drops out or reads implausibly.
  5. Subsystem check Inspect the sensor and tone ring for metal debris and damage near the hub.
  6. Verify the repair Clear the code, complete a full drive cycle including the conditions from the freeze frame, and confirm U0417 does not return.

Approximate repair cost

Repair cost depends on which component actually failed. Typical scenarios for U0417 (parts and labor, USD, independent shop rates): ABS module repair or replacement: $400–$1,200; Repair sensor wiring: $80–$250; Replace a wheel speed sensor: $120–$350. Overall, fixing U0417 usually costs between $80 and $1,200. An accurate diagnosis before buying parts saves money — the most expensive scenario is rarely the first one to check.

Common questions

What is the most common cause of U0417?

The most common causes are: blown fuse or low voltage to the ABS module, failed wheel speed sensor, damaged sensor wiring or corroded connector.

What are the symptoms of U0417?

Drivers most often notice: ABS not operating during hard braking, speedometer or cruise control issues, ABS or ESC warning light on, brake pedal pulsation changes.

Will U0417 clear itself?

Sometimes U0417 clears after a few drive cycles if the fault was intermittent — for example a loose connector or a tank of bad fuel. The underlying cause usually remains, so the code tends to return. Clear it once; if it comes back, diagnose rather than erase it repeatedly.

Is it safe to drive with U0417?

The base brakes usually still work, so careful driving is possible — but ABS and stability control are disabled, which lengthens stopping distances on slippery roads. Fix promptly and avoid harsh driving.

How much does it cost to fix U0417?

ABS module repair or replacement — $400–$1,200; Repair sensor wiring — $80–$250; Replace a wheel speed sensor — $120–$350. Exact cost depends on the root cause, your vehicle and local labor rates — a proper diagnosis is the cheapest first step.

What does U0417 mean?

U0417 is logged by the onboard diagnostics when the ABS / stability control does not behave as expected. The official definition is “Invalid Data Received From Park Brake Control Module”. This is a vehicle network category code.

The module monitors this system continuously while driving. When readings fall outside the expected range for a defined number of drive cycles, it stores U0417 and switches on the warning light. Freeze frame data saved with the code shows the exact conditions — rpm, load, temperature, speed — at the moment the fault was detected, which is the best starting point for diagnosis.

What causes U0417?

  • damaged sensor wiring or corroded connector
  • faulty ABS module or pump motor
  • damaged tone (reluctor) ring on the hub
  • failed wheel speed sensor

Common symptoms of U0417

  • ABS not operating during hard braking
  • speedometer or cruise control issues
  • ABS or ESC warning light on
  • brake pedal pulsation changes
  • stability control disabled message

How to diagnose U0417

  1. Connect an OBD2 scanner, confirm U0417 is stored, and save the freeze frame data — it shows engine conditions when the fault was detected.
  2. Related codes often reveal the real root cause. Also check manufacturer technical service bulletins (TSB) for your make and model — many U0xxx issues have factory fixes or software updates. Search by VIN on the manufacturer site or nhtsa.gov.
  3. Visually inspect the wiring harness and connectors related to the ABS / stability control for damage, corrosion, chafing or poor contact.
  4. Read all four wheel speed PIDs while driving slowly — the faulty sensor drops out or reads implausibly.
  5. Inspect the sensor and tone ring for metal debris and damage near the hub.
  6. Clear the code, complete a full drive cycle including the conditions from the freeze frame, and confirm U0417 does not return.

How to fix U0417

Start with the cheapest and most common causes before replacing expensive parts:

  • ABS module repair or replacement — $400–$1,200
  • Repair sensor wiring — $80–$250
  • Replace a wheel speed sensor — $120–$350

How much does it cost to fix U0417?

Repair cost depends on which component actually failed. Typical scenarios for U0417 (parts and labor, USD, independent shop rates):

  • ABS module repair or replacement: $400–$1,200
  • Repair sensor wiring: $80–$250
  • Replace a wheel speed sensor: $120–$350

Overall, fixing U0417 usually costs between $80 and $1,200. An accurate diagnosis before buying parts saves money — the most expensive scenario is rarely the first one to check.

Can you drive with U0417?

The base brakes usually still work, so careful driving is possible — but ABS and stability control are disabled, which lengthens stopping distances on slippery roads. Fix promptly and avoid harsh driving.

Related OBD2 codes